LEGRAND DA-LITE Tensioned Advantage Series, User Manual

Page: 17 / 61

17
Follow these steps if your screen and roller assembly was ordered separately from the case.
1. Remove the access door. First, remove the 2
screws from the ends using a #2 Phillips
screwdriver. Be sure to support the door during
this step to avoid injury. Then lift the door slightly
and pull away from the edge of the case (Figure 1).
2. Carefully unpack screen and roller assembly. Use a
5/16" socket or wrench and a #2 Phillips
Screwdriver to remove shipping brackets attached
to slat. Remove fabric and roller assembly from
shipping board using a 1/2" wrench. Leave packing
paper on roller.
3. To install screen and roller assembly, loosen (but
do not remove) four 1/4-20 nuts securing pin end
bracket (opposite end from the junction box) to the
case housing. Slide the pin end bracket towards
the end of the case (Figure 2).
4. Insert the motor end square shaft into the motor
end bracket (junction box end) and secure with the
cotter pin (Figure 2).
5. Moving to the pin end of the case, slide the pin end
bracket until the hole fits securely over the pin and
secure with the cotter pin. Tighten the 1/4-20 nuts
on the pin end bracket securely (Figure 2).
6. Complete electrical hook-up by snapping motor
wire connector into case connector (Figure 2).
8. Test installation by running screen up and down a
few times. Be prepared to stop screen should any
objects obstruct the movement of the screen. To
prevent damage to the motor, the standard duty
cycle is 1 minute on and 3 minutes off.
9. Re-install the access door. Procedure is the reverse
of step 1 listed above.
#2 Phillips
Screwdriver
Tools required for screen and roller assembly:
1/2", 1/4" and 5/16"
Open Wrench
or Socket Driver
Motor Mount
Bracket
Motor Power
Connector
1/4-20 Nuts
Access Door Screws
Foam Blocks
Pin End Motor End
Cotter Pins
Motor
SCREEN AND ROLLER ASSEMBLY
INSTALLATION
Figure 1 Figure 2