LEGRAND DA-LITE Tensioned Advantage Series, User Manual

Page: 56 / 61

56
1. Place operating switch in “down” position.
2. When the screen stops, turn the white “down”
limit knob
(Figure 4) one-quarter turn counterclockwise.
Test by raising picture surface approximately two
feet, then lower again. Repeat until desired
picture surface position is attained.
CAUTION: Do not adjust for more drop than what
was ordered. At least 1-1/2 wraps of fabric must
remain on the roller. This screen comes standard
with 12" black at the top.
ATTENTION! N'effectuez pas de réglage pour
obtenir un déroulement supérieur à celui
commandé. Au moins 1 à 1/2 tour de toile doit être
maintenu sur le cylindre. Ce écran est doté de
série d'une bande noire supérieure de 30,5 cm (12
po).
1. Raise picture surface approximately two feet
above
desired level.
2. Place operating switch in “off” position.
3. Turn the white “down” limit switch (Figure 4)
one-quarter turn clockwise. Test by raising
picture surface approximately two feet, then
lower again. Repeat until desired picture surface
position is attained.
CAUTION: Adjusting the down limit switch for
less drop by more than 6" can cause the screen
surface to lose proper tensioning.
ATTENTION! Le fait d'ajouter ne déroulez pas trop
l'écran plus de 15 cm (6po) aux interrupteurs de
fin de course peut faire perdre la bonne tension à
la surface de l'écran.
More Screen Drop
Less Screen Drop
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are
properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the
following manner:
NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments.
Figure 4
Screen Motor
LVC Control Box
Screen Motor
Limit Switches
SCREEN ADJUSTMENT