46
If your screen was shipped with the motor and roller already installed proceed to step 9.
1. Remove four bolts from ends of door assembly (2
bolts on each end) (Fig. 1). This will allow the door
assembly to drop open for access to case. For larger
sizes, you will also need to remove the door support
screws.
2. Carefully unpack screen and roller assembly. Leave
packing paper on the roller.
3. Remove the square peg bracket from the motor end
of the roller assembly.
4. Remove the safety clip from the motor attachement
bracket located in the motor end of the screen
housing.
5. Place the roller assembly into the case with the
motor on the left side. The limit switches should be
facing down. Line up the head of the motor with the
motor attachment bracket.
6. Loosen four bolts that secure pin end mounting
bracket into housing. Lift pin end of roller into
position and slide the bracket into the roller pin.
Tighten all four bolts.
7. Complete electrical hook-up by snapping motor 1/3
wire connectors into case connectors.
8. Return to motor end and insert safety clip over
casting bracket to secure motor end.
CAUTION! Do not cut tape on fabric with a knife
or any sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le ruban adhésif sur
la toile avec un couteau ou un outil tranchant.
Retirez à la main.
9. Carefully remove tape strips securing picture surface
around roller. Slat should move freely (Fig. 2). (Only if
the roller assembly is pre installed.)
10. Test installation by operating the screen several
times. Be prepared to stop the screen. The door
assembly will not close until the wall switch is placed
in the up position and when the screen motor stops
at its limit switch in the up direction.
NOTE: Unit duty cycle is 1 minute on, 3 minutes off.
NOTE: Excessive continuous operation may cause
the motor to overheat. If this happens the motor will
shut off until it cools to a normal operating
temperature.
11. Close door assembly and replace four bolts at ends
of door (2 bolts on each end) (Fig. 1).
Figure 2
Dual Motor LVC
Control Box
Screen Motor
Limit Switches
Screen Motor
Door Motor
Limit Switches
Door Motor
Access Door
Assembly
SCREEN AND ROLLER ASSEMBLY
INSTALLATION
Summary of Contents for DA-LITE Tensioned Advantage Series
