36
UP
STOP
DOWN
BUS
C
O
M
5V
RJ-14 Jack
(Connection to
Wall Switch)
RJ-14
Jack (QEYE)
5/12 Volt
Screen Trigger
on Projector
Black
Red
VPI Trigger
Module
CAUTION:
The projector must be turned off
before connecting the trigger wires to the
projector. Failure to do so may damage the
controller.
ATTENTION: Le projecteur doit être éteint avant
de brancher les fils de déclenchement à celui-ci.
Tout manquement à cette instruction pourrait
endommager le contrôleur.
Use 2-conductor 18–24 gauge wire to extend the low
voltage connection from the projector’s 5 or 12-volt
screen trigger output to the length required to reach the
VPI.
NOTE: When extending the low voltage connection
from the projector’s screen trigger output polarity does
not matter.
The red and black wires from the VPI are
interchangeable.
IMPORTANT NOTE: The wall switch is REQUIRED to
make any limit switch adjustments, EVEN if a third party
control system is used. Therefore, it is advised to wire
the switch or provide a 3-conductor connection that is
accessible.
3-conductor 20–24 gauge wire can be used in place of
the supplied RJ-14 6P4C cable to connect the wall
switch. Connect the BUS terminals on the wall switch to
the corresponding BUS terminals on the splitter board.
See 120V or 220V wiring diagram for complete wiring
instructions.
OPTIONAL BUILT-IN VIDEO PROJECTOR
INTERFACE
Summary of Contents for DA-LITE Tensioned Advantage Series
