11. ETHERNET REMOTE CONTROL
132
11.3 SNMP
By using SNMP (Simple Network Management Protocol), you can control an LV 7770 from
SNMP managers. Additionally, you can notify the SNMP managers of errors that the LV 7770
generates.
The LV 7770 supports SNMPv1.
11.3.1
SMI Definitions
IMPORTS
MODULE-IDENTITY, OBJECT-TYPE, NOTIFICATION-TYPE, enterprises
FROM SNMPv2-SMI
DisplayString
FROM SNMPv2-TC
OBJECT-GROUP, MODULE-COMPLIANCE
FROM SNMPv2-CONF;
11.3.2
Procedure
1. Configure the Ethernet settings on the LV 7770's ETHERNET SETUP tab.
Set the IP Address, and set SNMP READ to WRITE and SNMP TRAP to ON.
Reference 7.2.2, "Configuring Ethernet Settings"
SYS
→
F
•
2
SYSTEM SETUP →
F
•
3
NEXT TAB →
Figure 11-3 ETHERNET SETUP tab
2. Press
F•1
COMPLETE.
The message "Saving data - Please Wait" is displayed.
3. If you changed the IP address, after the message disappears, restart the LV 7770.
The new IP address will take effect.
4. Connect the LV 7770's Ethernet port to the network.
Use a UTP cable (category 5).
