![background image](http://html1.mh-extra.com/html/lavor/hyper-l/hyper-l_manual_680871024.webp)
exaust flow.
- The chimney section A must be 3 times the outlet
chimney of the machine B and at distance of at
least 20 cm.
It must be underlined that the above
recommendations are extremely important to
prevent the condensate from back dripping
into the machine. The exausts contain
sulphuric acid, condensating at a temperature
of approximately 180° C. The condensation
shall be avoid, but in any case the condensate
from chimney shall not enter the machine.
The non observance of these recommendations
may lead to the damage of the machine.
CHIMNEY SECTION: 3 times the area of chimney
Chimney pipe diameter = 150 mm
CHIMNEY SECTION FOR 2 BOILER: 6 times the area
of chimney
Chimney pipe diameter = 225 mm
> INSTALLATION AND START-UP
(fig.
)
FILLING UP WITH FUEL
Information on the type of diesel fuel to be used:
Diesel for transport uses and without additives.
Fill the tank with the fuel indicated on the
technical data plate
(Diesel)
Avoid that the tank is empty when the machine is
running in order not to damage the fuel pump.
WARNING:
Incorrect fuel shall not used as they as
provide hazard.
FILLING UP WITH DETERGENT
the detergent tank with the suggested products, su-
itable for the kind of washing to be carried out.
WARNING:
Make use only of liquid detergent, do not
absolutely use acid or too much alkaline products. We
suggest you to make use of our products, which have
been studied for the use with washer machines.
> INSTALLATION
(fig.
)
- Check that the master switch is turned to
“OFF” and that the water filter is fitted into
the pump’s inlet pipe.
- Screw the snap connection into place by hand,
without the aid of tools.
- Connect the water supply hose to the snap
connection. The hose must have an inside
diameter of at least 13 mm (1/2”).
- Connect the high pressure hose to the pump’s
outlet pipe. Press the high pressure hose
coupling fully down and then screw into place
by hand without the aid of tools.
- Connect the high pressure hose to the gun.
- Turn the water tap fully on. The water
temperature absolutely must be below 40°C.
IMPORTANT:
The washer machine has to
operate with clean water in order to avoid any
damages to the washer machine itself.
- Release the gun safety catch and keep the
trigger pressed, allowing the water to flow until
all the air has been expelled.
- Fit the lance into the gun.
- Fit the nozzle into the lanxce.
- Connect the plug to the power socket.
> 1ST START-UP
When starting up for the first time or after a long pe-
riod out of use, connect the intake line only for a few
minutes so that any dirt is vented from the delivery
outlet
> START-UP
(
fig.
)
- Whenever using the high-pressure cleaner, users are
urged to hold the gun in the correct position, with one
hand on the grip and the other on the spray rod.
- To start the machine, press the gun trigger
and at the same time turn the master switch to
“ON”
> TO WASH WITH HOT WATER
(fig.
)
- turn the burner switch and select the desired
temperature setting.
- To add detergent or disinfectant to the water
jet, open the regulator to the setting for
the quantity required as described in the
“DETERGENT SUCTION” section.
WARNING:
In case of operation indoors,
adequate ventilation and gas venting must be
assured.
EN
24
Summary of Contents for Hyper L
