- 52 -
ETHERNET/IP (LCBETHEIP only)
INSTRUMENT SETUP
-
(default:
): it allows to select the reading/writing of the byte in LITTLE-ENDIAN or BIG-
ENDIAN mode
-
: BIG ENDIAN
-
: LITTLE ENDIAN
-
(default: 10.2.0.170): set instrument IP address
-
(default: 255.255.255.0): set instrument Subnet Mask
-
(default: 0.0.0.0): set Gateway address of Ethernet network
In order to apply the changes, press until the display shows
.
PC/PLC SETUP
The instrument works as
adapter
in an Ethernet/IP network and features a dual port that allows to
exchange the weight and the main parameters with an Ethernet/IP
scanner
.
Use one of the following communication types.
CLASS 1 CONNECTION (implicit messages)
Refer to one of the following procedures to configure the communication with the instrument:
-
load the eds file attached to the instrument to the Ethernet/IP
scanner
development system
(see table “32-BIT RUN/IDLE HEADER” for the output data interface);
-
use a generic Ethernet/IP module: configure it with the parameters of the table “Parameters
for class 1 communication” and choose the real-time transfer format from instrument to
scanner (Target to Originator – T2O) between “32-BIT RUN/IDLE HEADER” and “PURE
DATA” (see the respective tables for the output data interface).
Parameters for class 1 communication
Assembly
Assembly Instance
Size [Byte]
32-bit run/idle header
Size [Byte]
Pure data
Input
101
22
26
Output
100
10
10
Configuration
128
0
0
