- 21 -
COMMUNICATION INTERFACE
OCR (OUTPUTS CONFIGURATION REGISTER)
Bit 7
Bit 6÷5
Bit 4
Bit 3
Bit 2÷1
Bit 0
0 -
1 -
00 -
01 -
10 -
11 - not used
0 -
1 -
not used
00 -
01 -
10 -
11 - not used
0 -
1 -
WRITING
READING
Write the OCR value in W1.
Write the output number (1÷3) in W2.
Send command 1125 to CMDR.
Write the output number (1÷3) in W2.
Send command 1124 to CMDR.
Read the output number in R2.
Read the OCR value in R1.
Examples: outputs configuration
OCR CONTENTS
OUTPUT CONFIGURATION
Binary
Hexadecimal
Decimal
00000000
0x00
000
/
/
/
/
10110001
0xB1
177
/
/
/
/
INPUTS
Default: input 1 =
input 2 =
Possible operation modes:
-
(NET/GROSS): by closing this input for no more than one second, it’s making an
operation of SEMI-AUTOMATIC TARE and the display will show the net weight. To display the
gross weight again, hold the NET/GROSS input closed for 3 seconds.
-
: by closing the input for no more than one second, the weight is set to zero (see section
WEIGHT ZERO-SETTING FOR SMALL VARIATIONS (SEMI-AUTOMATIC ZERO)
).
-
: keeping the input closed the maximum weight value reached remains on display. Opening
the input the current weight is displayed (see section
PEAK (BASE program)
).
-
: closing the input no operation is performed, the input status may however be read remotely
by way of the communication protocol.
-
: when the input is closed the weight is displayed based on the set coefficient (see section
SETTING UNITS OF MEASURE
), otherwise the weight is displayed.
-
: closing the input for max one second the weight is transmitted over the serial connection
according to the fast continuous transmission protocol only once (only if the
protocol is
set, see section
SERIAL PROTOCOLS (LCBRS485 and LCBRS485ANA only)
).
