Tool:
n
Open-end wrench size 41
n
Open-end wrench size 46
1.
The constant temperature equipment is switched off.
2.
Lay two hoses between the flow controller and the application.
3.
Connect the outlet of the application to the input of the flow con-
troller. The input on the flow controller is labeled RETURN USER.
4.
Connect the input of the application to the output of the flow
controller. The output on the flow controller is labeled OUTFLOW
USER.
5.
Screw the union nut onto the connecting sleeve clockwise. Tighten
up the union nut on the connecting sleeve clockwise. While doing so,
brace the connecting sleeve with a second open-end wrench.
n
The heat transfer liquid should only be filled using the constant tem-
perature equipment.
Read the operating manual of the constant temperature equipment for
instructions.
n
The properties of the heat transfer liquid used can be found in this oper-
ating manual and in the operating manual of the constant temperature
equipment.
Connecting an application
Fig. 8: Connection side towards the appli-
cation
Filling the thermostatic circuit with heat
transfer liquid
V2
Flow controller MID 80
17 / 38