Lantronix
Install Guide, SISPM1040-362-LRT and SISPM1040-384-LRT-C
23
of
51
4.
Connect the PC to any port on the switch using a standard Ethernet cable, and check the port LED on
the switch to make sure the link status of the PC’s is OK.
5.
Run your Web browser on the PC, and enter the factory default IP address, to access the switch’s Web
interface. If your PC is configured correctly, the login page of the switch displays as shown in Figure 10.
Figure 10: Web UI Login page
If you do not see the above Login page, perform these steps:
- Refresh the web page.
- Check if there is an IP conflict issue.
- Clean browser cookies and temporary Internet files.
- Check your PC settings again and repeat step 2.
6.
Enter the factory default Username (
admin
) and Password (
admin
) on the Login page.
7.
Click “Login” to log into the switch. The startup page displays; see the
Web User Guide
.
We recommend changing the default credentials before deploying in the network.
Note
: The factory default Username (
admin
) and the factory default Password (
admin
) are case-sensitive.
Connect the Switch to a Windows 10 PC
1.
Go to your PC’s Control Panel > Network and Internet.
2.
Click on Network and Sharing Center.
3.
Click on Change adapter settings.
4.
Select the first available Ethernet connection:
5.
Right click on it and go to Properties.
6.
On the Networking tab, select Internet Protocol Version 4(TCP/IPv4).
7.
Click on the Properties tab.
8.
Click the “Use the following IP address” button.
9.
Give the same IP subnet as the switch: 192.168.1.5 (your switch.77), Subnet mask: 255.255.255.0.
10.
Click OK.
11.
Connect your network cable from your PC to your switch.
12.
In your web browser address bar type the IP for the switch (192.168.1.77) and hit Enter.
13.
Enter the default User name (admin) and Password (admin) all lower case.
