Lanier LD225, Fax Manual

Page: 83 / 236

Sub Transmission Mode
73
4
Stamp
The optional ADF is required.
When sending a fax document using
the ADF, the machine can stamp a cir-
cle mark at the bottom of the original.
When sending a two-sided document,
the document is marked at the bottom
of the front page and top of the rear
page. This stamp indicates that the
original has been successfully stored
in memory for Memory Transmis-
sion, or successfully sent by Immedi-
ate Transmission.
Note
❒
Stamp only works when scanning
from the ADF.
❒
When the stamp starts getting lighter,
replace the cartridge. See “Replac-
ing the Stamp Cartridge”,
General
Settings Guide .
❒
If a page was not stamped even though
the Stamp function is turned on,
you need to resend that page.
❒
If you use this function often, you
can set the default in General Set-
tings and Adjustment so that this
function is always on. In this case,
Stamp can easily be turned off for
any single transmission by press-
ing
[ Stamp ] . See p.145 “General Set-
tings/Adjustment”.
❒
A paper jam during Parallel Mem-
ory Transmission may cause the
transmission to fail even if stamp-
ing is performed.
❒
You cannot turn the Stamp function
on or off while an original is being
scanned.
A
Place the original, and then select
the scan settings you require.
Reference
p.15 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.34 “Scan Settings”, Facsimile
Reference <Basic Features>
B
Press [ Sub TX Mode ] .
C
Press [ Stamp ] , and then press [ OK ] .
Note
❒
To cancel the stamp, press [ Stamp ]
again before pressing
[ OK ]
.
D
Specify the destination, and then
press the
{
Start
}
key.
Transmission Options
This section describes various func-
tions that you can switch on and off
for any particular transmission, fol-
lowing the procedures given here.
In addition, if you frequently use a
certain option configuration, you can
change the default home position (on
or off) of each option.
RussianC4-EN_Combine-F_FM.book Page 73 Tuesday, April 5, 2005 8:22 PM