Lanier LD225, Fax Manual

Page: 23 / 236

Polling Transmission
13
1
F
Press [ OK ] .
“ pppppppppp ” ap-
pears.
The type of Polling Transmission is
shown above the highlighted
[ Poll-
ing TX ]
.
G
Press
[ OK ]
.
Note
❒
To check the settings, press [ Trans-
mission Mode ] .
H
Press the
{
Start
}
key.
Note
❒
You can cancel the transmission
setup for Polling Transmission.
See p.19 “Canceling a Transmis-
sion”.
Polling Transmission Clear
Report
This report allows you to verify Poll-
ing Transmission has taken place.
If E-mail TX Results is programmed
in a Quick Operation key, you can have
the report e-mail sent after transmission.
See p.146 “Quick Operation Key”.
Limitation
❒
This report is not printed if the
User Parameters are set to allow
the stored originals to be repeated-
ly sent (Save). See p.167 “User Pa-
rameters” (switch 11, bit 7).
Note
❒
You can turn this function on or off
with the User Parameters. See p.167
“User Parameters” (switch 03, bit
6).
❒
You can have a portion of the sent
image printed on the report with
the User Parameters. See p.167 “User
Parameters” (switch 04, bit 7).
❒
You can check the result of Polling
Transmission with the Journal. See
p.27 “Printing the Journal”
❒
To view the report without text disrup-
tion, select a font of even character
width in your e-mail application's
settings.
❒
You can display a destination with
the User Parameters. See p.167 “User
Parameters” (switch 04, bit 4).
❒
You can indicate the sender's name
with the User Parameters. See p.167
“User Parameters” (switch 04, bit
5).
RussianC4-EN_Combine-F_FM.book Page 13 Tuesday, April 5, 2005 8:22 PM