Lanier LD225, Fax Manual

Page: 187 / 236

Using Administrator Settings
177
9
Limitation
❒
One forward destination can
be registered for each Special
Sender. To register two or more
forward destinations, use
group destinations. However
a maximum of 500 parties
can be specified in a group.
Note
❒
Press the button on the right of
the display to switch the desti-
nation between fax number, e-
mail address, IP-Fax destina-
tion, and folder.
❒
Set folder destinations using the
Address Book Management
function under System Settings.
See “Registering Folders”,
General Settings Guide .
❒
When a folder is specified as
the forward destination, you
can set a file format for for-
warding. See p.167 “User Pa-
rameters” (switch 21, bit 3).
❒
Deleting a destination speci-
fied as a forward destination
from the destination table
causes the settings of the for-
ward destination to be delet-
ed, so they must be registered
again. When a destination is
changed, a document is trans-
mitted to the new destina-
tion. If there is no destination
of the specified type, you can
set which destination to be
used as an alternative desti-
nation. See p.167 “User Pa-
rameters” (switch 32, bit 0).
D
Press
[ OK ]
.
E
Press [ OK ] .
Note
❒
After you perform step
K
, set
“Forwarding” of “Reception
Settings” to “On”. See p.147
“Reception Settings”.
Reception File Print Qty
A
Select [ Reception File Print Qty ] .
B
Press [ Number of Sets ] .
Note
❒
Selecting [ Same as Basic Set-
tings ] will result in the same
setting made for “RX File Print
Qty” of “Reception Settings”.
See p.147 “Reception Set-
tings”.
C
Enter the print quantity using
the number keys, and then press
[ OK ] .
Note
❒
If you make a mistake, press
[ Clear ] or the
{
Clear/Stop
}
key
before pressing [ OK ] , and then
try again.
RussianC4-EN_Combine-F_FM.book Page 177 Tuesday, April 5, 2005 8:22 PM