Lanier AP2145, Setup Manual

Page: 307 / 424

Remote Maintenance by telnet
67
6
❒
The Network Interface Board is reset automatically when the settings are
changed.
❒
When the Network Interface Board is reset, the active print job which has
already been sent to the machine will finish printing. However, jobs that
have not been sent yet will be canceled.
Commands List
Use this command to display remote maintenance use.
Note
❒
Type “help” to see a list of commands that can be used.
msh> help
❒
Type “help command_name” to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the ifconfig command to configure TCP/IP(IP address, subnet mask, broad-
cast address, default gateway address) for the machine.
❖
❖ ❖
❖
Reference
msh> ifconfig
❖ ❖ ❖ ❖
Configuration
msh> ifconfig interface_name parameter address
*1
If you did not enter the interface name, it will be automatically set to the Ethernet in-
terface.
*2
Available when the 1394 Interface Unit Type 4510 is installed.
Interface name Interface to be configured
ether
sie0
Ethernet Interface
*1
ip1394
*2
fwip0
*2
IEEE 1394 Interface
Parameter Meaning
(no parameter) IP address
netmask subnet mask
gateway default gateway address
broadcast broadcast address