Lanier AP2145, Setup Manual

Page: 287 / 424

NetWare 3.x - Advanced Settings
47
4
Setting Up as a Remote Printer
AAAA
Log on to the file server as a Supervisor or a Supervisor equivalent.
BBBB
Run the NIB Setup Tool.
Reference
⇒
p.40 “Running the NIB Setup Tool”
CCCC
Click [ Property Sheet ] and click [ OK ] .
The [ NIB Setup Tool - Network board list ] dialog box of the Network Interface
Board appears.
DDDD
Click [ IPX protocol ] .
EEEE
Click the IPX address of the Network Interface Board which is to be config-
ured, and then click
[ Next > ] .
Note
❒
If you do not know which Network Interface Board you are configuring,
see a network configuration page to check the MAC address (Network Ad-
dress).
FFFF
Make sure that the MAC address and IPX address are correct, and then click
[ Finish ] .
The [ NIB Setup Tool ] window appears.
GGGG
Click [ Configure ] .
The property sheet appears.
HHHH
Click the [ General ] tab, and then type the name of the print server into the
[ Device Name ] box.
IIII
Click the [ NetWare ] tab, and then make the following settings.
A A A A
In the [ Print Server Name ] box, type the name of the print server.
B
B B
B
In the [ File Server Name ] box, type the name of the file server in which a
print server is to be created.
Clicking
[ Browse ]
, you can select a file server among those listed in the
[ Browse ] dialog box.
C
C C
C
In the [ Print Server Operation Mode ] group, click [ As Remote Printer ] .
D
D D
D
In the
[ Remote Printer No. ]
box, type the printer number.
Important
❒
Use the same printer number as that to be created in the printer server.
E
E E
E
Click [ OK ] to close the property sheet.
F F F F
After the confirmation dialog box appears, click [ OK ] .