Laguna Tools PFLUX2, Manual, Page: 32 / 50

Mobile Dust Cyclone Manual
31
1. Keep the cyclone switched ON and operating, open both sides of the Canister filter shield
doors. Connect the 4
” flex hose from the cyclone to the 4 ” hook up on the canister end
cap.
Figure 7: Cleaning Filter
2. While the cyclone is collecting the dust from inside the canister end cap, use compressed
air and an air gun and blow the outer surface of the canister.
3. After cleaning the filter with the compressed air gun, follow the steps in the next section
to remove the end cap to empty out any dust left inside.
EMPTYING THE CANISTER END CAP
Periodically check the canister end cap, if it is more than one third full, it is recommended
that you empty it.
NOTE:
If the canister end cap gets too full, the dust particulates may be recirculated back
into the canister filter obstructing air flow and exposing the user to potentially harmful
particulates.
1. Release the (4) latches around the canister end cap to remove it.
2. Empty the end cap and reattach using the latches.
EMPTYING THE DRUM
Periodically inspect the contents of the drum and empty as needed. To inspect the contents
of the drum:
1.
Raise the drum foot pedal bar to lower the drum to the floor.
2. Roll it away from the machine, inspect and empty as needed.
HEPA FILTER REPLACMENT
To maintain safe, clean air quality, the HEPA filter should be replaced after 2000 hours of
operation (e.g., 8 hours/day x 250 days = 2,000 hours). Contact your dealer or Laguna
Tools for a replacement HEPA filter. If your model has a “change filter indicator light” it will
flash at 2,000 hours. Replace HEPA filter. To reset flashing light, press the “Remote” button
on the Control Panel 5 times.