Laguna Tools PFLUX2, Manual, Page: 19 / 50

Mobile Dust Cyclone Manual
18
1. Remove (2) 5/16 ” x 5/8 ” hex
bolts on the motor plate (shown
by red arrow). Install (2) 5/16
” eye
bolts (not supplied) on the motor
plate. With the help of another
person, lift the upper cyclone
assembly using a forklift. Make
sure to hold the opposite side of
the dust chute to prevent swaying
while lifting the assembly up.
2. Remove the base which has
been bolted to the (3) top upright
supports. Keep the (6) 3/8
” x3/4 ”
hex bolts and (6) 3/8 ” flat washers
for assembling the lower supports
to the base. Keep the upper
assembly lifted for step 5.
3. Turn base upside-down. Use (16)
5/16
” x 3/4 ” hex bolts and (16) 5/16 ”
flat washers. Attach the (2) 4 ” casters
with brakes to the base. The casters
with brakes should be attached to the
side with the opening. The remaining
(2) 4
” swivel casters must attach to
the other side of the base.
4. Turn the base over with it
standing on the (4) 4” casters and
secure the three lower upright
support panels using (6) 3/8” x
3/4” hex bolts and (6) 3/8” x 7/8”
flat washers.
A – shown with one dot is located
on the canister side.
B
– shown with two dots is located
on the front side.
C
– shown with three dots is
located on the opposite end.
A
B
C
A
B
C
Swivel caster
Swivel caster
With brakes