Laguna Tools PFLUX2, Manual, Page: 31 / 50

Mobile Dust Cyclone Manual
30
NOTE: An (appx.) 8’ cord is included and can be used for 220 Volt operation. A “plug” is
NOT included and must be installed by a qualified technician.
OPERATION
1. Make sure at least one blast gate is open, if connected to a dust collection system with
blast gates.
Never operate dust collector with all blast gates closed!
2. Confirm the electrical supply is correct and connected to machine.
3. Make sure no one is working on or doing maintenance to dust collector.
4. To start, press the ON button on either the ON/OFF switch or remote control.
5. To stop, press the OFF button on either the ON/OFF switch or remote control.
MAINTENANCE
CLEANING THE FILTER
The PFLUX2 and PFLUX3 is equipped with auto clean; every 10 minutes for 10 seconds one
direction and another 10 seconds the other direction. The cleaning will continue for one
cycle (10 seconds clockwise, 10 seconds counterclockwise after the machine is turned OFF.
While the canister is cleaning the yellow LED light on the control panel will illuminate
indicating it is in the process of cleaning.
There is a HEPA filter replacement indicator, which is the same yellow LED light as the
cleaning light. This is based on a timer system and when 2000 hours of operation is
reached, the light will flash in one long, two short intervals indicating the HEPA filter should
be replaced.
Pressing the REMOTE button five times will reset the flashing light.
To ensure proper operation of this Mobile Dust Cyclone, the HEPA canister filter must have
adequate air flow. This means the filter must be regularly maintained by carefully blowing
the filter clean using compressed air and an air gun to release built-up particulates trapped
between the filter pleats.
DISCONNECT MACHINE FROM POWER!
For heavy duty users, it is recommended to use compressed air on a weekly basis to
maintain maximum filtration efficiency and longer life span of the filter.