Lagler Flip, Handling, Maintenance, Safety

Page: 10 / 44

10
4 Pull off the worn-out Velcro sanding disc from the sanding
plate (Fig. 8).
5 Place a new Velcro sanding disc on the sanding plate. The
Velcro sanding disc must be seated in centered position on
the sanding plate. A drilled hole in the center of the sanding
disc and the universal spanner make this step easier (Fig. 9).
4.2.2 CONVENTIONAL SANDING DISCS
1 Switch off the machine.
2 Always pull the power supply plug out of the socket!
3 Turn the machine upside down or lay it on its side, avoiding
damage to the floor and machine.
4 Use the universal spanner to loosen the fixing screw of the
paper tensioning device (Fig. 10).
5 Rotate the fixing screw all the way out. Remove the paper
tensioning disc from the sanding plate and put these parts
aside (Fig. 11).
6 Put on a new sanding disc and insert the fixing screw in the
sanding plate together with the paper faceplate (Fig. 12).
7 Turn the fixing screw in the sanding plate using the univer-
sal spanner (Fig. 12); make sure the sanding disc is fastened
in centered position on the sanding plate.
8 Tighten the fixing screw with the universal spanner until it
is hand-tight.
Always mount one sanding disc only, since otherwise the sanding
results will be unsatisfactory and the dust suction system not be
fully operational!
Fig. 9 ... and mount the new disc in centered position and
press down.
Fig. 10 Remove conventional sanding disc by loosening the
fixing screw with the universal spanner and ...
Fig. 12 ... mount a new disc and assemble again.
Fig. 11 ... after removing, take off the paper faceplate, ...
REPLACING THE SANDING DISC
4
Pricing in this catalog is outdated