Lagler Flip, Handling, Maintenance, Safety

Page: 8 / 44

8
Fig. 3 Push the dust bag over the locating flange and fix
with the two metal studs.
Fig. 4 Secure the dust bag using the quick-release
fasteners.
Fig. 6 Use the switch to switch on and off.
Fig. 5 Connect the motor cable to the extension cable.
4 The fan tube can be turned through 360°, whereby four fixed
positions are possible in which the stop bolt snaps into place
in the tube.
Always select one of these four positions to avoid
accidents or damage to the machine!
5 Push the dust bag opening over the locating flange fixed to
the end of the elbow piece and fix the dust bag using the
two metal studs (Fig. 3).
6 Fix the dust bag to the locating flange using the two quick-
release fasteners (Fig. 4).
3.2 CONNECTING THE POWER SUPPLY CABLE
1 Insert the plug of the motor cable in the coupling of the
extension cable (Fig. 5).
2 Fasten the extension cable coupler using the Velcro loop
on the dust bag.
3 Insert the extension cable in a suitably protected 230-volt
socket or 110-volt socket according to specified power
supply.
3.3 STARTING THE MACHINE
The FLIP is now ready to be started. When starting the machine,
the sanding disc must be raised from the floor therefore, tilt the
machine back first. You may then use the switch to start the
machine (Fig. 6).
3.4 SWITCHING OFF THE MACHINE
To switch off the machine, tilt it back so that the sanding disc is
raised off the floor and press the switch. Wait until the sanding
disc comes to a standstill before you stand the machine back on
the sanding disc.
Never let the machine run unattended and always pull the power
supply plug out of the socket when you have finished working
with the machine.
GETTING STARTED
3
Pricing in this catalog is outdated