Lagler Flip, Handling, Maintenance, Safety

Page: 16 / 44

16
CHANGING THE V-BELT
6
6.2 CHANGING THE V-BELT
Make sure that original LÄGLER V-belts are used (Art. no. in
Section
11, Spare parts
).
The V-belt must be replaced when the V-belt cannot be re-
tightened because the screws for fastening the attachment are at
the end of the long holes.
1 Switch off the machine and always pull the power supply
plug out of the socket!
2 Turn the machine upside down, place it on its side or with
the motor housing on a table, at the same time avoiding
damage to the floor and machine.
3 Undo the belt tightener plate screw using the universal
spanner, turn it so that it faces the back and then retighten
the screw (Fig. 30).
4 Use the universal spanner to remove the two screws,
washers and guide angles that fix the attachment and place
the parts to one side (fig. 31).
5 Remove the attachment from the machine and put away the
attachment with the sanding disc facing upward (Fig. 32).
6 Use the universal spanner to remove the fixing screws of
the attachment cover and remove it from the attachment
(Fig. 33).
7 Turn the attachment around.
8 Use the universal spanner to loosen the four fixing screws
of the steel sanding disc and unscrew them (Fig. 34).
9 Then remove the attachment from the steel sanding disc
(Fig. 35).
10 Remove the worn-out V-belt from the attachment.
Fig. 30 Loosen the screw, turn away the belt tightener plate
and retighten the screw.
Fig. 31 Remove the two screws with which the attachment
is fastened.
Fig. 32 Remove the attachment from the machine.
Fig. 33 Remove the attachment cover.
Pricing in this catalog is outdated