Lagler Flip, Handling, Maintenance, Safety

Page: 21 / 44

21
To adjust the guide rollers, proceed in the following manner:
1 Switch off the machine and always pull the power supply
plug out of the socket!
2 Loosen the locknut of the guide roller to be adjusted.
3 Hold the appropriate universal spanner alignment mark for
attachment used between the guide roller and fan housing,
namely so that the lettering on the spanner faces towards
the fan housing (Fig. 44 + 45).
Alignment mark - short attachment: short
- long attachment: long
- corner attachment: short
4 Now turn the guide roller in the direction required and re-
tighten the locknut.
5 Perform a trial sanding operation and check the sanding
results (Fig. 46 – 50). Should you require a steeper or flatter
setting, loosen the locknut again and turn the guide roller
one or two turns in the relevant direction and then tighten
the locknut again.
Fig. 47 Sanding zone too far to the right means, ...
Fig. 48 ... the left-hand wheel lifts the machine too far.
Fig. 50 ... the right-hand wheel lifts the machine too far.
Fig. 49 Sanding zone too far to the left means, ...
ADJUSTING THE GUIDE ROLLERS
6
Pricing in this catalog is outdated