Lagler Flip, Handling, Maintenance, Safety

Page: 17 / 44

17
CHANGING THE V-BELT
6
11 Clean the two belt pulleys and the attachment. Wear a
respiratory protective mask (P3) as required.
12 Place the new V-belt on the steel sanding disc.
13 Insert the steel sanding disc and the V-belt in the
attachment. Ensure that the holes in the steel sanding disc
are aligned with the holes of the attachment (Fig. 36).
14 Make sure that the sanding plate can be rotated by hand
and that the V-belt was correctly installed in the
attachment.
15 Tighten the four countersunk head screws for fixing the
steel sanding disc using the universal spanner (Fig. 37).
16 Then place the attachment on the machine by inserting the
V-belt into the motor belt pulley first and then the
attachment on the machine (Fig. 38).
17 Fit the attachment cover.
18 Now turn the screws in the screw thread of the fan housing.
Ensure that the guide angles and washers are fitted under
the screws.
19 Now tighten the V-belt as described in Section 6.1 .
Following a running-in period, check the belt again!
Fig. 34 Unscrew the four fixing screws of the steel sanding
disc.
Fig. 35 Remove the attachment from the steel sanding disc.
Fig. 36 Insert the steel sanding disc into the attachment
with the V-belt. Ensure that the holes in the steel
sanding disc are aligned with the holes in the
attachment.
Fig. 38 Insert the V-belt into the motor belt pulley.
Fig. 37 Tighten the four countersunk head screws to fix the
steel sanding disc.
Pricing in this catalog is outdated