Lagler Flip, Handling, Maintenance, Safety

Page: 20 / 44

20
6.6 CHECKING THE DUST SUCTION SYSTEM
In order to guarantee optimal dust suction for your safety and for
the safety of other persons, the following items must be taken into
account:
• Always use original LÄGLER dust bags FLIP (Art. no. in
Section 11, Spare parts
).
• Do not use any damaged dust bags.
• Ensure that the guide rollers are correctly positioned.
• Check the suction system for any clogged-up material or
deposits.
• Make sure that the dust bag and locating flange are
connected properly.
6.7 ADJUSTING THE GUIDE ROLLERS
The position of the guide rollers will have an effect the sanding
results and the aggressiveness of the machine. For rough sanding
tasks, a large setting angle is selected. For fine sanding tasks, a
flat setting angle.
The two alignment marks on the universal spanner can be used to
set a position for the guide rollers, which is suitable for both rough
and fine sanding work, for the short and long attachment.
This is achieved by holding the corresponding alignment mark of
the universal spanner, that depends on the attachment used,
between the guide roller and the fan housing and this spacing is
then set (see below for procedure).
This setting allows a horizontal and even sanding setting, which
does not overload the machine and leads to an even and attractive
sanded finish.
In special cases the setting must be adjusted to the circumstances,
however it is easy to find the standard setting again using the uni-
versal spanner.
The high cutting speed of the machine allows you to work fast.
The machine must be moved quickly without applying extra
pressure. If a higher amount of removed material is demanded,
the setting angle must be adjusted to a steeper setting!
CHECKING THE DUST SUCTION SYSTEM
6
Fig. 44 Standard setting for the short attachment and the
corner attachment.
Fig. 45 Standard setting for the long attachment.
Fig. 46 Correctly adjusted, machine is sanding centrically.
Pricing in this catalog is outdated