Lagler Flip, Handling, Maintenance, Safety

Page: 25 / 44

25
TROUBLESHOOTING
8
Troubleshooting
This section shows you how to eliminate possible malfunctions.
In case none of the measures mentioned here are not successful,
please contact LÄGLER.
MACHINE DOES NOT RUN
The machine does not start
• Check the power supply system and the fuse.
• Let the electrical equipment be checked by an electrician
(e.g. switches, motor cable).
• The machine has been switched off by means of the ther-
mal sensor (due to undervoltage in the current supply or
excess pressure on the attachment during sanding work)
and must cool off!
The machine tries to start but is blocked
• At low temperatures: Heat up the machine to room
temperature in a warm room.
• Low voltage: Check the cable quality and cable length.
Avoid the use of cable cross-sections that are too small
(cross-sections smaller than 1.5 mm²) and power supply
cables that are too long. Use a transformer as required.
• Check and adjust the V-belt tension.
MACHINE RUNS BADLY
Machine runs, but no or very little sanding power capacity
• At low temperatures: Heat up the machine to room
temperature in a warm room.
• Low voltage: Check the cable quality and cable length.
Avoid the use of cable cross-sections that are too small
(cross-sections smaller than 1.5 mm²) and power supply
cables that are too long. Use a transformer as required.
• Check and adjust the V-belt tension.
• Check the driving elements for free-running condition.
• Setting angle is too flat.
• Incorrect or dull sanding disc.
8
Make sure that the maintenance tasks in the service passport
are confirmed by filling in a corresponding field with complete
information including the date, stamp and signature.
Pricing in this catalog is outdated