![background image](http://html1.mh-extra.com/html/l-b-white/torchman-500-171bc/torchman-500-171bc_owners-manual_3089264011.webp)
Spécifications de la torche
171BC
Type de combustible
Gaz-Propane
Puissance maximum (BTUH)
500,000 @ 90PSI
Pression du réservoir
Consommation de combustible a l’heure (lb) 23.2
10 ft. (3.04 m)
3 lb. 7 oz.
Modèle
Poids net
(IComprend le tuyau de gaz, les pro-
duits pétroliers et la valve)
Distance sécuritaire minimale des con-
teneurs prévus pour la distribution de gaz
propane
Pression de l'alimentation de gaz
à l'admission requise à l'entrée de
la torche
(cylindres de 20, 50 et 100 lb)
SPÉCIFICATIONS
■
The area surrounding the torch shall
be kept clear and free from com-
bustible materials, gasoline, and other
flammable vapors and liquids.
■
Review labels at the time of mainte-
nance for legibility. Make sure none
are cut, torn, or otherwise damaged.
Any damaged labels must be replaced
immediately by contacting L.B.White.
Labels are avaialble at no cost.
Maintenance Instructions
Service Instructions
■
Close the fuel supply valves to the torch
and allow the torch to cool before servic-
ing
■
Do not push instruments into the burner
orifice hole. Doing so may enlarge or dis-
tort the hole creating improper combus-
tion,or burner flame blow out.
-- Use only a soft brush, dry rag, or
pressurized air to clean the burner
orifice.
■
Do not use pliers to loosen or tighten
torch components. Doing so may round
off the component creating service prob-
lems. Use the appropriate wrench.
■
Leak check all gas connections after per-
forming service work. Use approved leak
detectors.
Troubleshooting Information
PROBLEMS
CAUSES REMEDIES
1. Burner will not light.
* Valve closed on torch *Open valves.
or at fuel supply.
* Cylinder or tank low on fuel *Fill cylinder/ tank.
* Burner orifice plugged. *Clean the burner
orifice.
* Gas hose blocked. *Remove hose
and blow out
with air.
2. Burner flame lifting
* Blockages in burner orifice or at *Clean with soft
off burner, or burner
primary air inlets of burner. brush, dry cloth,
flame blows out.
3. Burner flame is small.
* Gas supply valves not fully open *Open all valves
* Burner orifice plugged. *Clean it
* Cylinder low on fuel *Replace or refill.
* The check valve in POL fitting *Close fuel supply
is locked. valve and wait
to allow check
valve to reset it-
self.
11
18