KYOWA WGA-670B, Instruction Manual

Page: 17 / 60

12
4-2 FUNCTION
4-2-1 Various Functions in Function Selecting Mode
• Function selecting mode has the following 14 functions.
F-01: Original value F-08: Additional Value
F-02: Actual Load Calibration F-09: Automatic ZERO Compensation
F-03: Sensitivity Registering Calibration F-10: Hysteresis
F-04: Hold Mode F-11: BCD Output Logic
F-05: Self Check F-12: Initialize
F-06: D/A Output Scale F-13: BV Select
F-07: Smoothing F-14: TEDS ON/OFF
• For details of each function, see the following Table 4-2-1.
Table 4-2-1 Various Functions in Function Selecting Mode
Function
Selecting Mode
Function Name
Key Operation & WGA-670B
Movement in Function Setting Mode
Functional
Description
F-01 Original Value ‘. . . . . ’ is indicated.
Press the SET key at this time and the
current input value is indicated in the unit
of mV/V. •A function that
indicates the raw
output value of
the transducer.
F-02
Actual Load
Calibration Conduct digital ZERO function with no
load applied to the transducer.
Then, apply load to the transducer.
Set a numerical value to be indicated at
this time and press the SET key.
Next, set a decimal point position and
press the SET key.
•Key code enable setting
‘00000’ is indicated.
Here, set the indication to read ‘00628’ or
‘11111’ and press the SET key. Then,
calibration value is updated.
The key code is enabled. Therefore, when
the calibration value is updated the next
time, the above operation is required. To
disable the key code, use the function
‘F-12.’
•Key code disable setting
‘00000’ is indicated.
Press the SET key as it is.
Then, the calibration value is updated.
The key code is disabled and the
calibration value is updated even if no
key code entered.
•A function that
applies the actual
load to the
transducer and sets
the indicated value
of that time.
● Before conducting
the actual load
calibration, do not
forget to conduct
digital ZERO
function.