35
Transmitter’s Firmware Ver. 2.00 or later
Power ON
Waiting
Measured data
Receiver
Transmitter
Wireless
communication
Power ON
Waiting
Send command response
Receive command response
Waiting
START send command
Waiting
Receive command
Command processing
Start measurement
Receive measured data
Receive measured data
Measured data
.
Power OFF
Power OFF
[Command Mode]
STOP send command
Waiting
Waiting
Receive command
Command processing
Send command response
Receive command response
[Measuring Mode]
Measured data
[Command Mode]
[Command Mode]
[Command Mode]
.
.
Waiting
Command processing
[Measuring Mode]
Measured data
Measured data
Start measurement
Receive measured data
Receive measured data
Measured data
.
STOP send command
Receive command
[Measuring Mode]
Measured data
.
.
[Measuring Mode]
Measured data
[Command Mode]
●Instantaneous power failure and recovery on the receiver
Although not included in the aforementioned diagram that shows the communication sequence, if the
receiver power instantaneously goes out for whatever reason while in Measuring Mode, after the receiver
is restarted, Measuring Mode resumes on the receiver when it receives packets from the transmitter.
However, when this occurs, the "BAL" LED and "MUTE" LED are not lit.
MEMO
Summary of Contents for MRS-100 Series
