KYOWA MRS-100 Series, Instruction Manual

Page: 20 / 81

19
●When measurement cannot be ended promptly
The first attempt to end measurement may not be successful if there are timing issues between the timing of
packet transmission and "STOP" command transmission from the receiver.
In this case, try pressing the "STOP" switch repeatedly to end measurement, with a short interval between
each attempt.
m) "STOP" switch
The "STOP" switch is for ending (stopping) measurement.
Press the "STOP" switch to transition from Measuring Mode to Command Mode.
• When measurement ends normally:
1) When the "STOP" switch is pressed, the "START" LED turns off.
2) Output of measurement data from the receiver’s analog output stops.
3) The "LOCK" LED, "DATA" LED, "Transmitter’s battery voltage checking" LEDs, and "RSSI" LEDs turn
off.
4) The product transitions from Measuring Mode to Command Mode.
• When measurement fails to end normally:
1) When the "STOP" switch is pressed, the "DATA" LED lights up in red, and the buzzer sounds.
(The buzzer does not sound if "MUTE" is off.)
2) The product remains in Measuring Mode, and output of measurement data continues.
"START" LED "DATA" LED Status
Off
●
Off
●
Switched to Command Mode. Measurement is finished
normally.
Lit in green
●
Lit in red
●
(Lit for three seconds)
Cannot transition to Command Mode, and the product continues
to measure in Measuring Mode.
Press the "STOP" switch again.
n) "Tx OFF" switch
Hold down the switch for at least three seconds to turn off the transmitter.
Once Tx OFF is executed, the transmitter remains off until it is manually restarted.
• When executed normally:
1) Hold down the "Tx OFF" switch for at least three seconds.
2) The "DATA" LED lights up in green.
One to three "Transmitter’s battery voltage checking" LEDs and one to three "RSSI" LEDs also light up in
green.
3) Tx OFF is executed, and the transmitter powers off.
• If measurement fails to start normally (due to a wireless communication error, etc.):
1) Hold down the "Tx OFF" switch for at least three seconds.
2) The "DATA" LED lights up in red, and the buzzer sounds.
(The buzzer does not sound if "MUTE" is off.)
3) Tx OFF is not executed, and the transmitter remains in standby in Command Mode.
"Battery voltage checking"
"RSSI" LED
"DATA" LED Status
Lit in green
●
(Lit for three seconds)
Lit in green
●
(Lit for three seconds)
Tx OFF was executed normally.
Off
●
Lit in red
●
(Lit for three seconds)
Tx OFF was not executed normally.
Try again in an environment that enables normal wireless
communication.
MEMO