KYOWA MRS-100 Series, Instruction Manual

Page: 6 / 81

5
CAUTION
● Caution
Be sure to observe the safety precautions described in the MRS-114A Instruction Manual.
● Do not turn ON the power switch immediately after turning it OFF.
After turning OFF the power switch, wait (5 seconds) until the power supply is shut OFF before turning ON the
power switch again.
To disconnect the product, turn controls to off, then remove plug from wall outlet.
● Use within the operating temperature range.
Use at temperatures exceeding the specified range may lower the performance and cause trouble.
● Use within the operating humidity range (however, without condensation).
Use in a humid place exceeding the specified range or where it is exposed to splashing water may lower the
performance and cause trouble.
● Use the product at the altitude up to 2,000m.
● Do not use the product immediately when the ambient temperature and humidity change suddenly.
Leave the product as it is until it becomes adaptable to the environment.
Abrupt change in ambient temperature due to transportation, etc. may cause dew condensation, which may result
in lower performance and troubles.
● Use the product under environment without excessive vibration or high impact.
Use the product in an area where vibration and impact can be kept within the scope of specifications.
Continuous vibration or severe impact may cause deteriorated performance and system failure.
In case of installing the product at high place, prepare enough measures for prevention of its drop.
● This product operates on the 2.4 GHz band, which wireless LAN, Bluetooth
®
, and microwave ovens also use.
Devices on the wireless LAN or on other radio waves may generate electromagnetic interference that causes
wireless communication errors in this product.
Before using this product, check to confirm that there are no such devices nearby.
In addition, note that the wireless LAN and Bluetooth
®
functions of the computer on which the Setting Software
for this product is installed may generate electromagnetic interference. When controlling this product via the
computer, turn off the computer’s wireless LAN and Bluetooth
®
functions.
Use the product as far away from other signal lines and noise sources as possible, in order to prevent it from
malfunctioning due to noise.
Keep this product far away as possible from equipment which generates strong electromagnetic wave.
● Do not use the product under poor conditions.
Operate the product within the range of power supply specs. The power supply used for the product should not
experience an instantaneous power failure and be free from noise.
● Do not pull cords and cables.
Lay cords and cables with a certain allowance so that unreasonable force is not applied to the connections.
Or, it may interrupt the measurements, break the cables, and damage the connectors.
● Avoid installing sensors and products near a welding machine. Failure to do so will pose the risk of erroneous data,
malfunction and failure.
● Do not disassemble or remodel the product. Or, it may cause electric shock hazards or damage the product. This
warranty does not cover any damaged or defective parts that results from disassembling or remodeling.
● Do not use or storage the product under dusty or fine particles or corrosive gas environment.
Use or storage under these environments, may result in lower performance and troubles.
● Do not expose the product to the air if it is used and stored nearby sea. Air exposure nearby sea may cause lower
performance and products failure.
● Take care when handling the CD-R.
Do not expose the CD-R to direct sun light, high temperature, or high humidity.
Do not apply pressure to the CD-R by laying object or bending.
Dust, scratches, and fingerprints on either side of the CD-R can cause write errors.