Kyocera Mita FS-9100DN, Operation Manual

Page: 13 / 145

Chapter 1 Name of Parts
1-2
1
Operator panel
Contains the keys and indicators for operating the printer.
2
Front cover
Open to replace the toner container or waste toner box.
3
Paper cassette 2
Second cassette that holds up to about 250 sheets of stan-
dard paper.
4
Paper guide
Adjust to the length of the paper to be set in the paper cas-
sette.
5
Paper stopper
Hold the lever and adjust the paper guide to the width of the
paper to be set in the paper cassette.
6
Paper cassette 1
First cassette that holds up to about 250 sheets of standard
paper.
7
Handles for transport
Hold these handles by more than 4 persons when lifting or
moving the printer.
8
MP (Multi-Purpose) tray
Load paper here when printing onto small-size or special pa-
per.
9
Main switch
Turn ON ( I ) before starting to print.
0
Face-down tray
Printed paper is stored here.
A
Toner container
B
Toner container release lever
Operate to replace the toner container.
C
Waste toner box
Waste toner is collected.
D
Cleaning knob
Pull and push back in after toner container replacement or
when print images become soiled with toner.
E
Main charger unit
When replacing the toner container, install the grid cleaner to
clean the grid.
F
Cleaning brush
Used to clean the internal part of the printer.
G
Power cord
H
Power cord connector
220 to 240 V-models only.
I
Option unit connector
When using the option device, connect its cable to this con-
nector.
J
Handles for transport
Hold these handles by more than 4 persons when lifting or
moving the printer.
K
Left cover 2
Open when a paper jam occurs inside the left cover 2.
L
Lock cover
Pull up to open the left cover 1.
M
Left cover 1
Open when a paper jam occurs.
N
Memory card slot
O
Optional network interface card slot (OPT2)
For optional network interface card.
P
Parallel cable connector
Connect the parallel cable to this connector in the parallel
printing.
Q
Network cable connector
Connect the network cable to this connector in the network
printing.
R
Serial cable connector
Connect the serial cable to this connector in the serial print-
ing.
S
Optional hard disk unit slot (OPT1/HDD)
For optional hard disk unit.
N
O
P
Q
R
S