Kyocera Mita FS-1050, Operation Manual

Page: 26 / 209

Using the Operator Panel
1-16
1 — Software Version
This contains the firmware version and date of issue of the printer.
2 — Hardware Information
This contains information about the printer settings, such as the size and
type of paper in the paper cassette.
3 — Memory
This contains the total amount of memory installed in the printer, the
amount of available memory and the current status of the RAM disk. See
Setting the RAM Disk Setting the RAM Disk Setting the RAM Disk Setting the RAM Disk
on page
1-56 1-56 1-56 1-56
.
4 — Page Information
This shows the print resolution, number of copies and the total page count.
5 — Installation Options
This shows which options are installed in the printer.
6 — Network Status
This shows the IP address, Subnet Mask address, Default Gateway address,
and other settings for the network interface card installed in the printer.
7 — Emulation
This shows all available emulations of the printer. The default printer
emulation is PCL6.
8 — Error Log
This shows the last three instances of the following six types of errors,
listed in order of occurrence:
KPDL Error Press GO
;
Memory overflow
Press GO
;
Print overrun Press GO
;
File not found Press GO
;
MemoryCard err Press GO
;
RAM disk error Press GO
. The most
recent error is displayed on the top line of the Error Log. For error
remedies, see
Chapter 4 Chapter 4 Chapter 4 Chapter 4
. Error information is cleared when the printer’s
power is turned off.
9 — Toner Gauge
This shows the approximate level of remaining toner. When the value is
100, the toner container is full. The closer to 0, the smaller the amount of
remaining toner.
10 — Interface Information
This shows the default font and emulation for all interfaces installed in the
printer.