KYMCO AHG5, Service Manual

Page: 328 / 363

19. ELECTRICAL SYSTEM
DT X360
19-12
7. Oil pressure sensor
7.1. Inspection
Check the engine oil level is at the standard
before inspection.
The engine oil pressure will maintain in a
certain pressure after start the engine.
To inspect the oil pressure sensor, the
ignition switch should be turned on.
The engine oil pressure indicator should
light up automatically after turn on the
ignition switch.
If the indicator does not come up, perform
the following inspection process.
1. Remove the protective cap to disconnect
the wire.
2. Connect the wire to ground directly to
check if the indicator comes up
automatically.
3. If the indicator does not light up still,
check any of following situation: blown
fuse, poor connecition of , short circuit.
The engine oil pressure indicator should go
off automatically after run the engine.
If the indicator does not go off, perform the
following inspection process.
1. Inspect for oil leakage or seized situation.
2. If none of the above situations occur, the
engine oil pressure sensor should be
replaced.