KYMCO AHG5, Service Manual

Page: 269 / 363

14. FRONT ASSEMBLY
DT X360
14-7
Wheel Rim
Place the wheel on a truing stand and use a
dial indicator to check if the rim is out of
true. The specifications for the front and rear
wheels are the same. Check for lateral
wobble. The service limit is 2.0 mm (0.08 in)
or less.
Check for radial hop. The service limit is 2.0
mm (0.08 in) or less.
Service Limit:
Axial: 2.0 mm
Radial: 2.0 mm
Apply grease to the collar, and then install
the collar onto the wheel.
Disassembly 3.3.
Replace bearings as a set, and do not reuse
old bearings.
Place the new bearings in the freezer about
an hour before you plan to install them.
Do not let the wheel rest on its brake disc.
Remove the side collar and dust seal.
The seal should be replaced with a new
item.
Turn the inner race of each bearing with
your finger to see if they turn smoothly and
quietly. Also check if the outer race fits
tightly in the hub.
Replace the bearings if the races do not turn
smoothly, quietly, or if they fit loosely in the
hub.