KYMCO AHG5, Service Manual

Page: 47 / 363

3. PERIODIC MAINTENANCE
DT X360
3-14
9.5. Oil filter replacement
Change the engine oil with the engine at
normal operating temperature and the
scooter on its center stand to assure
complete and rapid draining.

Let the engine and exhaust system
cool before working in those areas.
1. Remove the oil filler cap/dipstick (1)
from the right crankcase cover.
2. Place a drain pan under the crankcase.
Remove the oil filter cap and O-ring.
3. The spring will come out when the filter
cap is removed.
Let the engine oil drain out.
4. Remove and discard the oil filter.

Do not remain the rubber seal on the
oil filter in the oil filter housing.
Check that the O-ring is in good condition.
5. Install the new oil filter.
Cap bolt torque: 1.2 kgf-m
6. Install the spring, O-ring and cap.
Cap bolt torque: 1.2 kgf-m
7. Fill the crankcase with the
recommended grade oil and install the
oil filler cap.
Oil capacity (after draining): 1.0 liter
8. Start the engine and let it idle for 2
－
3
minutes.
9. Stop the engine and check that the oil
level is at the upper level mark on the oil
filler cap/dipstick with the scooter upright
on firm, level ground. Make sure there
are no oil leaks.

Make sure the rubber seal on the oil
filter facing the left crankcase.