KYMCO AHG5, Service Manual

Page: 46 / 363

3. PERIODIC MAINTENANCE
DT X360
3-13
9.4. Oil strainer screen clean
Change the engine oil with the engine at
normal operating temperature and the
scooter on its center stand to assure
complete and rapid draining.

Let the engine and exhaust system
cool before working in those areas.
1. Remove the oil filler cap/dipstick (1)
from the right crankcase cover.
2. Place a drain pan under the crankcase
and remove the oil strainer screen cap
(2).
3. The oil strainer screen (3) will come out
when the drain plug is removed.
4. Let the engine oil drain out.
5. Clean the oil strainer screen.
6. Check that the oil strainer screen,
sealing rubber and drain plug O-ring are
in good condition.
7. Apply light coat engine oil on the
O-rings.
8. Install the oil strainer screen, washer
and oil strainer screen cap.
Oil strainer screen cap torque: 1.5 kgf-m
9. Fill the crankcase with the
recommended grade oil and install the
oil filler cap.
Oil capacity (after draining): 1.0 liter
10. Start the engine and let it idle for 2
－
3
minutes.
11. Stop the engine and check that the oil
level is at the upper level mark on the oil
filler cap/dipstick with the scooter upright
on firm, level ground. Make sure there
are no oil leaks.