This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
- KYMATI GmbH – 2021
KY.MAN.0105 (6.0)
KY-LOC 1D.02.01 User Manual
Doc.- No.: KY.MAN.0105
Version:
6.0
Date:
14.12.2021
Page:
36 of 83
8
Establishing a UDP Connection
For configuring the radar devices, a UDP connection must be established with the local host.
The Kymati Commander application only supports Microsoft Windows XP or higher.
Additionally, two ports (27513, 27515) on the Firewall must be allowed to pass through the
UDP packets. A description is provided below:
8.1
Ethernet settings
The local machine and the radar units shall be in the same network. The default IP address of
the radar units is 192.168.75.100 (Master) respectively 192.168.75.101 (Slave). The
destination IP address is 192.168.75.1 and the subnet mask is 255.255.255.0. Therefore, for
the first-time usage the IP address of the local machine must be in that network. If the IP
settings will be changed after uploading a configuration, then the IP settings on the local
machine shall be also changed. The following figure shows the network settings on Microsoft
Windows.
Figure 21: Setting up the Network Settings on the local machine
After establishing the right IP settings on your local machine then you can verify if the radar
units using the ping command. The ping command can be executed following the steps:
Press the start button on windows
Choose or type Run
