This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
- KYMATI GmbH – 2021
KY.MAN.0105 (6.0)
KY-LOC 1D.02.01 User Manual
Doc.- No.: KY.MAN.0105
Version:
6.0
Date:
14.12.2021
Page:
30 of 83
6
Setting Up the Devices and System Operation
This chapter describes how to operate the sensor. The following steps must be taken to have
a basic measurement running:
1. Install the devices
(see chapter 6.1)
2. Power up the devices
(see chapter 6.2)
3. Configure the devices
(see chapter 09)
4. Do the first measurement run
(see chapter 6.5)
After this procedure, the system is correctly installed and will start automatically measuring if
both sensors are powered and synchronized.
6.1
Installation of the Sensor
For a proper operation, the following parts must be considered:
The devices must face each other. For long range operation they should be aligned
better than 5°.
A minimum distance of 2 m between the two units must be maintained to guarantee
the specified accuracy.
The orientation of the two devices must be the same (please refer to chapter 3.2).
The vertical and horizontal offset must be smaller than 0.3 m.
