Kval 990FX, Operation And Service Manual

Page: 79 / 172

About the Setup Screen
2-49
KVAL Operation/Service Manual
Calibration Steps for the Lock Location
The
Lock Location Calibration
uses the X axis to tune the lock location. See “Entering Calibration
Offsets” on page 2-48 for information about entering data. Below is a illustration on face plate
movement.
Lock Location Calibration
FIGURE 3.
Reference Door Lock
Lock Location
• The
Base, 6’-8“, and 8’-0”
calibration sections set the dis-
tances of the
LH and RH Stops
from the
Home Limit
as a ref-
erence.
• 6’ 8'' and 8’ 0'': Tunes the distance of the stops from the
reference (HOME) for LH and RH doors of each door
length.
Note:
8’ 0” Door is an Option
To start, run a known good lock cut at a standard location on
a Right Hand or Left Hand door.
Once the lock cut is completed, check the distance from the
top of the door to the center of the lock.
Note the measurement value and compare to specification
If the lock location is correct, there is no need to perform
this process, If it is not correct, follow the instructions in See “Adjusting
Lock Location” below.
Measure