Kurabo QuickGene-810, Operation Manual

Page: 59 / 78

QuickGene-810 Operation Manual
Rev. 1.7
35
4 Maintenance
1
3
2
5
4
6
7
(8) Take off the Pump Tube from the pump,
and attach a new Pump Tube to the rear
of the Pump Cover.
Slide the connectors at the ends of the Pump Tube
into the grooves of the Pump Cover.
Check that the notches on both connectors are
facing the front of the Pump Cover.
Slide the Pump Tube into place inside the Pump
Cover by rotating the rotor.
Adjust the rotor to its original vertical position.
Use the Pump Tube as labeled "ELUTION Pump
Tube" or "WASH Pump Tube" for each pump.
Spare pump tube is available for either pump.
After this, the procedure is the same as in "How to
install the Pump Tube". For details, refer to "
■
Setup the Pump Tube"(
→
page 10).
Important:
Check the both end of the Pump Tube are
placed the grooves.
Note: Use the specified Pump Tube.
Pump Cover: Front Pump Cover: Rear
Pump Tube
Notch
Notches face front
Pump Tube
Groove
Rotor
Connector
Slide the Pump Tube
connector into groove