Kurabo QuickGene-810, Operation Manual

Page: 35 / 78

QuickGene-810 Operation Manual
Rev. 1.7
11
1 Installation
1
3
2
5
4
6
7
(a) Detach the pump cover.
Loosen and remove the screws to detach the
pump cover.
(b)Attach the Pump Tube to the rear of the
Pump Cover.
Slide the connectors at the ends of the Pump
Tube into the grooves of the Pump Cover.
Check that the notches on both connectors are
facing the front of the Pump Cover.
Slide the Pump Tube into place inside the
Pump Cover by rotating the rotor.
Adjust the rotor to its original vertical
position.
Use the Pump Tube as labeled "ELUTION
Pump Tube" or "WASH Pump Tube" for each
pump.
Spare pump tube is available for either pump.
(c)Attach the pump cover.
Turn the rotor vertical position, then re-attach
the pump cover to the retainer, making sure
that the drive head and drive socket are
correctly mated.
Secure the pump cover in place with the
original 2 screws.
Important:
Check the both end of the Pump Tube are
placed the grooves.
Important:
•Check the Pump Cover is fixed well to the
Rear. Then tighten the screws until the
spring washer is squeezed.
Pump Cover: Front Pump Cover: Rear
Pump Tube
Notch
Notches face front
Pump Tube
Groove
Rotor
Connector
Slide the Pump Tube
connector into groove
Pump cover: Rear
Fit together to attach
Rotor
Drive Socket Drive Head
Spring washer