48
Operation of the spreader
Non-return valve
The non-return valve prevents the inflow of brine at the end of the operation with damp salt. It also makes sure
that when the damp salt operation is switched on again brine is put out immediately.
With co-axial adjustment the non-return valve is at the
disc unit.
Do not tighten cover with a spanner – close only by hand.
With linear brine adjustment the non-return valve is located
in the upper area of the chute. When the chute is folded up,
the valve is in easy reach.
When folding up the chute the safety catches of of the chute must be put in.
If the connection hose between the brine pump and the non-return valve empties itself, it has to be checked
whether perhaps salt crystals have formed in the valve. Salt crystals at the valve can have a negative influence on
the tightness of the non-return valve.
To prevent crystals from forming, the non-return valve should be flushed during the
summer break.
Large debris filter
The large debris filter prevents large particals from entering the brine pump.
Never operate the spreaders without large debris filters. If the large
debris filter is missing the brine pump can be damaged.
To prevent the formation of crystals, the non-return valve should be flushed during the
sumer break.
Subject to changes
English
Summary of Contents for DUPLEX
