Chapter 05
41
www.kugelmann.com
Starting the spreader
Before driving check all fixations again. Is the spreader mounted in the correct position? Are all bolts fixed and
properly secured?
Operation of the equipment, its care, repair and maintenance must always be dóne by
instructed personnel.
Never work near the machine wearing loos clothes which can be caught in running parts.
Do not work on the machine while it is running!
STOP MOTOR AND EMOVE IGNITION KEY!!!
After shutting down the equipment tool/part of machine can still run on.
The spreading disc unit can be changed from transport mode to working mode with a few moves.
Draw fixing bolt of the locking device lever on the left side, turn by 90 degrees and snap into place.
Fold locking device lever upwards or to the front while holding on to the spreader unit. Swing spreader unit
downwards. Draw locking bolt (left and right one each), move securing lever downwards with handle knob until
the locking bolt snaps into the lower oblong hole. Make sure that both security levers are secured with the
securing bolts.
Subject to changes
Englsih
Summary of Contents for DUPLEX
