Kugelmann Maschinenbau DUPLEX, Operating Instructions Manual

Page: 26 / 60

During mounting the telescopic cylinder of the tip truck platform has to be secured
against unintended extension.
26
Mounting, dismounting of the spreader
Mounting of the spreader
With tripod
The company Kugelmann offers tripods with 3t and 5t total capacity as special accessory.
Notice: to the empty weight of the spreader comes the weight of the filling. The resulting total wieght must not be
exceeded under any circumstances.
Carrying load, danger for health and life!
The spreader is put high and is carried by a tripod.
Perhaps tie up cables and hydraulic hoses.Reverse slowly under the
spreader and watch out for the correct position.For safety use a
second person for giving directions. With the 4 hand cranks lower
the spreader together evenly until the load is staken up by the
carrying vehicle. Is the spreader loaded on the platform, it must, of
course, be positioned correctly.
The spreader is secured with lashing straps only at the 4 corners to
avoid shifting. For the first mounting the type of sercuring is
determined by the producer und must be observed by all means.
If the mountable spreader has an intermediate frame (spider), take
care that the the 4 claws of the intermediate frame fits into the balls
of the vehicle. Secure the structure aith the foreseen pin.
Afterwards remove the tripod parts.With 2 hydraulic connections, one flow line and one reverse flow (with load
sensing a third control line is added), the whole drive is, in priciple, connected.The two pipes cannot be
confused, the return flow is always the thicker pipe.
Always connect the pipe for the pressure free return flow first!
Subject to changes
E
ngl
is
h