Kugelmann Maschinenbau DUPLEX, Operating Instructions Manual

Page: 44 / 60

44
Opertion of the spreader
The screw-conveyors have to be completely filled with spreading material. Therefore, move the screw-conveyor
by hand over the flow divider block until the spreading material is delivered evenly. Empty buckets and place in
position.
The k-tronic is described in the detailed description for the dealer.
F lowchart overview
On the k-tronic
Detail menu Spreading
materials Salt, grit or brine
Impulse/kg Teachinleft or right (each screw conveyor separately)
Press left dial knob until at least 1800 Impulses are reached
Set the measured net weight at the dial knob in the middle
Save „OK" value with righ dial knob
Spreadpattern adjustment
Let vehicle run in neutral while parked in an appropriate place, the spreading material container is ideally half full .Switch on hydraulic system at the
vehicle if it does not have a hydraulicconveyor system which adjusts volume to performance (Load Sensing).
Manual operation on: keep key down on the left side pressed Press key on the right at the top Let both keys go again Press key
on the top right again (spreading mode) Screw and spreader disc are turning
Never work near machine wearing loose clothes which can get caught in running parts.
Do not work at running machine!
STOP MOTOR AND REMOVE IGNITION KEY!!!
Subject to changes
English
Spreadpattern adjustment
Let vehicle run in neutral while parked in an appropriate place, the spreading material container is ideally half full.
Switch on hydraulic system at the vehicle if it does not have a hydraulic conveyor system which adjusts volume to
performance (Load Sensing).
Manual operation on: keep key down on the left side pressed Press key on the right at the
top Let both keys go again Press key on the top right again (spreading mode)
Screw and spreader disc are turning