E
ngl
is
h
32
Mounting, dismounting of the spreader
Putting down of a spreader with Roll-Fix
Chose a level and stable parking space with sufficient room to drive forward from under the spreader.
Unplug the electric cables of the control at the socket box. Unscrew protective flaps of the connector plugs. Only
unscrew at the cap nut not at the connector housing.
Decouple the hydraulic pipes.
Unplug the cable of the Roll-Fix-additional lighting.
Place the cables such that they cannot be jammed and torn off when
the spreader is re-mounted.
Remove all fixing elements between the spreader and the carrying
vehicle.
Lower both supporting legs with a hooked up cable winch to the ground.
Secure each supporting leg with two bolts each. Use the lowest
possible pair of holes for the bolts. On both sides use the pair of holes
at the same height. Secure the bolts with the supplied safety
elements against sliding out..
Lift the tip truck dumping body slightly, while the supporting
legs are standing firmly on the ground. Drive slowly out until
the folding columns are folded down completely. The
indicators on the side then become visible.
Secure folding columns with safety bolts. Secure safety bolts
with safety elements against falling out.
Drive carrying vehicle out completely.
Subject to changes
Summary of Contents for DUPLEX
