Kugelmann Maschinenbau DUPLEX, Operating Instructions Manual

Page: 56 / 60

56
Maintenance and care, wear parts
Repairs at the varnish
With varnish works there is a fire hazard according to the directive of flammable
liquids. Danger of poisoning during varnishing work. Danger of injuries during polishing
work with rotating tools.
After the end of the spreading season it is reasonable to repair damages at the varnish of the spreader
equipment. Pay attention to danger notices! The partricular varnish colour can be ordered from the company
Kugelmann.
Welding work at the spreading equipment
The control must be connected during welding work.Otherwise disturbances at the processor and failure of the
control have to be expected.
Error diagnosis
If the fault „Sensor disc error“appears this can have several causes.
The spreading equipment does not receive any oil. Hydraulic onnections are not properly connected.
The srew conveyors are blocked.
The sensor is defect, a cable has been torn off.
Check sensor and sesor adjustment in the detail menu. See description „k-tronic detail menu".
Error „Disc undersupply".
The hydraulic system does not deliver sufficient oil.
Error „Disc oversupply"
Hand wheel at the flow divider block is open.
„Screw undersupply"
The hydraulic system delivers too little oil.
„Screw oversupply"
Hand wheel at the flow divider block is open.
„Undervoltage"
Check vehicle voltate of the carrying vehicle.
Subject to changes
English