CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091003 - KME 18-22-30-37 - REV. 07 - DATA 11/2016
pag.32 of 68
5.7.6
COMPRESSOR CONNECTION TO ELECTRICAL POWER SUPPLY
Make certain that the compressed air hoses used have adequate maximum pressure
rating and section for the compressor. Never repair defective hoses; they must always
be replaced.
Connect the compressor to the pneumatic system using the special G 1-1/4” female connection
arranged on the compressor and indicated in the figure.
It is recommended to use a hose having a diameter equal to or greater than the G 1-1/4" compressor
outlet.
Figure 8
A check valve is already installed inside the compressor.