KT&C Omni-IP KNR-p16Px8, User Manual

Page: 126 / 195

KNR-p4Px4 KNR-p16Px8 User Manual
126
9.2 Configuring Advanced Settings
9.2.1 Configuring PPPoE Settings
Purpose:
Your NVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the PPPoE tab to enter the PPPoE Settings interface, as shown in Figure 9. 2.
Figure 9. 2 PPPoE Settings Interface
3. Check the PPPoE checkbox to enable this feature.
4. Enter User Name , Password , and Confirm Password for PPPoE access.
Note: The User Name and Password should be assigned by your ISP.
5. Click Apply to save and exit the interface.
6. After successful settings, the system asks you to reboot the device to enable the new settings, and the PPPoE
dial-up is automatically connected after reboot.
You can go to Menu >Maintenance>System Info >Network interface to view the status of PPPoE connection. Please
refer to Chapter Viewing System Information for PPPoE status.
9.2.2 Configuring DDNS
Purpose:
If your site uses DHCP to control its WAN IP address you should use Dynamic DNS (DDNS) so it can keep track of the
current WAN IP address to insure that you will always be able to access your site. WWW.SIMPLEDDNS is
recommended, very easy to set up, and it is free. It can also be configured to remember the WAN port numbers required
for access if they have been changed from the defaults (as is often the case).
Prior registration with the service is often required before configuring the system to use DDNS.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the DDNS tab to enter the DDNS Settings interface, as shown in Figure 9. 3.