KSB Amaprop 1200, Mounting And Installation Instructions Manual

Page: 16 / 40

Caution
Amaprop R
16
Secure the bolted connections between the braces or
prefabricated bracing and the pump bracket with Loctite and
tighten to the below torques with a torque wrench. Do not forget
to fit the washers and lock nuts!
Amaprop
1200-1801
M16x70
Amaprop
2000-2500
M20x65; M20x80
Tightening torque 168 Nm 250 Nm
Then start positioning the feet on the tank floor until the foot
plate rests on the floor completely.
Incorrect: Incomplete contact!! Correct: Full contact
Secure the bolted connections M16x55 between the braces
and the feet with Loctite and tighten to 150 Nm with a torque
wrench. Do not forget to fit the lock nuts!
Mark out and drill the holes for the composite anchor bolts. Drill
bit diameter 18 mm; bore depth 125 mm. Even level foundation
floors have site--related tolerances. Therefore, the 4 holes for
the feet should only be drilled when the feet rest fully on the tank
floor (use slotted holes to adjust)! The hole pattern data for the
composite anchor bolts (dimensions F
A
, F
B
, F
C
) are for
orientation only; it is important that the feet rest fully on the floor!
Observe the installation instructions for the composite anchor
bolts given in section 3.1.
Note:
For sizes 2000--2500 the adjustable range of slotted holes is
restricted by the welding design of the bracket. As for sizes
1200--1801, for full contact between the foot plates and the floor
fill any remaining gaps with UPAT chemical mortar (see section
7.8). Observe the application instructions given on the
supplementary sheet! The mortar can only be applied when the
tank is empty and dry. Do not apply if there is still some minimal
water level in the tank (rainfall). The mortar cannot be applied
by divers.
Any unfilled gaps remaining will result in
increased stresses on the composite anchor
bolts.
This may damage the composite anchor bolts, the mixer and
the installation parts.
Inadequate filling of any gaps remaining can invalidate any
liability of the manufacturer for consequential damage.
Drill a hole with Ø 18 mm and clean it (e.g. with compressed air).
Verify bore depth (125 mm).